Water Pump Installation Method

1. If the geographical environment permits, the water pump should be as close to the water source as possible to reduce the length of the suction pipe. The foundation where the water pump is installed should be solid, and a special foundation should be built for fixed pump stations.
2. The water inlet pipeline should be sealed reliably, must have special support, and should not be hung on the water pump. The water inlet pipe equipped with a bottom valve should be installed so that the axis of the bottom valve is vertical to the horizontal plane, and the angle between the axis and the horizontal plane should not be less than 45°. When the water source is a channel, the bottom valve should be more than 0.50 meters above the water bottom, and a mesh should be added to prevent debris from entering the pump.
3. The base of the machine and pump should be level, and the connection with the foundation should be firm. When the machine and pump are driven by belts, the tight edge of the belt should be at the bottom, so that the transmission efficiency is high. The steering direction of the water pump impeller should be consistent with the direction indicated by the arrow; when using coupling transmission, the machine and pump must be coaxial.
4. The installation position of the water pump should meet the requirements for the allowable vacuum height. The foundation must be level and stable to ensure that the rotation direction of the power machine is consistent with the rotation direction of the water pump.
5. If there are multiple units in the same computer room, there should be a distance of more than 800mm between the units and between the units and the wall.
6. The water pump suction pipe must be well sealed, with as few elbows and gate valves as possible. The air should be exhausted when filling and water diversion. Air should not accumulate in the pipe during operation. The water suction pipe is required to be connected to the water inlet of the water pump at a slight upward angle. The water inlet should be There is a certain depth of submersion.